1985 Chevy C10 Perfect Project Truck. Over $5000 Invested In Power train with less than 5000 miles on motor trans and rear end. Motor is a Chevy 350, bored 30 over with aluminum heads (2.02 intake 1.60 exhaust valves), stage 2 Aluminum intake, Rollor rockers Harded push rods with rod guides flat top pistons, 273-265 duration cam, new cam, rod and main bearings, Eldebrock 600 cfm carb, aluminum high flow water pump, new oil pump, new a/c compressor, evaporator and condenser and converted over to R-134a,has cold air.new blower motor, re manufactured alternator, fuel regulator and pressure gauge on carb. 700R4 Transmission with lock up control in cab, new trans temp gauge all new clutch and friction plates, new seals and bands with aftermarket shift kit on valve body. Rear end has all new bearings and seals with new 3.08 gears. both fuel tanks have been cleaned and had new sending units installed with new fuel lines. New Fuel pump with water fuel separator and 100 micron filter before carb. 255/75R 5 tires with 3,000 miles on them. Truck just needs a little body and interior work. But nothing to major. All parts put on this truck are new and from summit racing, Jegs and Napa.Looking for cool / custom trades PLEASE don't offer a ride with a bad or no title ..If it has a salvage/ rebuilt/ flood / fire /theft /etc.no thanks clear- clean titles ONLY |