This is a 96' chevy s-10 with a 2003 sonoma front clip. Not really wanting to let it go, but if the right offer comes along then i will. Exterior: Just to keep it simple everything is shaved on it except for the fuel door. The tailgate is molded into the bed with a light bar for the taillights, the rollpan is also molded into the bed. The front windshield has cracks in it so it needs to be replaced. The bed has been re-sheetmetaled. It has 20" DUB (Big Homie) wheels wrapped in 245/35/20 Nitto tires. Interior: The truck does need a new gauge cluster. The stock seatbelts have been taken out and lap belts have been put in. The dash is primered in white. All the vents have been shaved. It still has the a/c compressor,condenser, and controls so if you want a/c it can still be hooked up. All it would need to work would be the hoses that run from the compressor to the condenser. It has a nitro alarm with remote start and door poppers on the driver side door only. Bags: This truck has been bagged by Fresh Rydes in Houston,Texas. It has firestone 2500 bags on all four corners, a Thomas 337, Firestone, and extra Thomas compressor, 7 gallon tank, all mounted underneath bed, front/back setup with 4 1/2" valves, all ran with 1/2" hardline. The only thing it has done under the hood is a cold-air intake, and the firewall has been tubbed to lay frame. Its a daily driver, rides really smooth on the highway, alright ride in town, gets very good gas mileage! The truck has two small dents in it, one is on the left side of the bed, the other is at the front of the hood. I just replaced the fuel pump and water pump. |